Instruction Manual

Chapter 2 : STARTING (continued) BROAD SCAN (HD/SDI)
2-2. SETTINGS
 We recommend resetting the BROAD SCAN to all of its default values, with the front panel display menu
(CONTROL
default valueyes) before proceeding.
 Select the auto-setting menu with the front panel display menu (INPUTAuto setting) and activate this function
with ENTER. This function detects automatically the input type of the source connected to the input connectors
(DVI & RGB). Then the device performs an auto-centering function.
 Select the Input status menu (INPUTInput status) to verify the correct detection of the type and format of your
input source. If a wrong message is displayed, select manually the type of your input source (INPUT
Input
Type).
 Select the output format and rate (OUTPUTFormat).
 For SDTV output format (PAL, NTSC) select the type of the RGB/YCrCb output (OUTPUTType).
2-3. IMAGE ADJUSTMENTS
 Select the UNDER/OVER scan mode with the front panel button.
 Adjust the position & size of the image with the front panel buttons.
 Adjust the level of anti-flicker with the panel display menu (IMAGEFlicker filter).
 Perform the others adjustments, available in the Image menu.
2-4. EMBEDDED AUDIO MODE
The embedded audio menu is available for BHD930 & BSD830 models only. The device allows embedding analog
audio stereo signal into the HD/SD-SDI output signals.
 Connect an analog audio stereo source to the AUDIO IN (L /R) connector.
 Activate the Embedded audio mode with the front panel display menu (AUDIOEmbed.ON).
 Adjust the audio level with the front panel display menu (AUDIOLevel).
 Adjust the audio balance with the front panel display menu (AUDIOBalance).
PAGE 16