User guide

CAUTION:
All of the safety and operating instructions should be read before the product is operated and should be
maintained for further reference. Please follow all the warnings regarding this product and its operating
instructions.
• WARNING: To prevent the risk of electric shock and re, do not expose the device to rain, humidity,
intense heat sources (such as heaters and direct sunlight). Slots and openings in the device are provided
for ventilation and to avoid overheating. Make sure the device is never placed near a textile surface that
could block the openings. Keep away from excessive dust and vibrations. Avoid shocks of any kind.
• POWER: Always use the power supply delivered with your device or a power supply that corresponds to
the power requirements indicated on your device…
The device is equipped with a main switch (On (I) Off (0)) on the rear panel.
• STANDYBY MODE: The machine has a standby mode that enables you to activate the power-saving mode.
Simply press the [MENU/EXIT] button for several seconds, the menu will then display the progress of the
standby setup. Once 100%, the machine will enter ‘sleep’ mode.
To wake the machine up simple press the [MENU/EXIT] button, a message will be displayed to inform you
that the machine is exiting standby mode.
• POWER CORD: Caution: The power cord is the only way to totally disconnect the equipment from the
main power.
Apply the following guidelines:
- The equipment connected to the network must have a release system easily
accessible and located outside the unit.
- Unplug the power cord, do not pull on the power cord but always on the plug itself.
- The outlet should always be near the device and easily accessible.
- Power supply cords should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them.
If the power supply cord is damaged, unplug the device. Using the device with a damaged power supply cord
may expose your device to electric shocks or other hazards. Verify the condition of the power supply cords
once in a while. Contact your dealer or service center for replacement if damaged.
• CONNECTIONS: All inputs and outputs (except for the power input) are TBTS dened under EN60950.
• SERVICING: Do not attempt to service this product yourself by opening or removing covers and screws
since it may expose your device to electric shocks or other hazards. Refer all problems to qualied
service personnel.
• OPENINGS: Never push objects of any kind into this product through the openings. If liquids have been
spilled or objects have fallen into the device, unplug it immediately and have it checked by a qualied
technician.
HARDWARE INSTALLATION
2-1. SAFETY INSTRUCTIONS
6