User Manual
14
4.2 Unpacking and inspecon
• 1 x
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device update)
• 1 x Remote Control Soware (RCS²)*
• 1 x Set of 6 audio 5-pin screw terminals
• 1 x Front rack ears (the parts are stowed in the packaging foam)
• 1 x User manual (PDF)*
• 1 x Quick start guide*
* User manual, quick start guide and the RCS² are available on www.analogway.com
Before racking and plugging any inputs and outputs, it is advised to power on the unit. Should you encounter
any issue, you must contact immediately your local distributor or dealer, or closest Analog Way technical
support oces (see chapter: 12. Contact informaon).
The Eikos² can be used directly on a table; the unit is equipped with 4 handy an-slip
rubber feet.
The Eikos² is compable with a 19” enclosure. Please follow the instrucons below to install
the device in a 19” rack.
Place the device in your rack. Aach the device to the rack by screwing 2 front ears on it (screws not included).
Rear xing is also recommended, in parcular for permanent installaons.
Connect all of the cables of the device and aach them to the rack with the help of e wraps.
IMPORTANT:
- The openings in the side of the device are for cooling. Do not cover these openings to avoid blocking air
circulaon.
- Be sure that no weight in excess of 2 kg (4.4 Lbs.) is added onto the Eikos².
- The maximum ambient operang temperature should not exceed 40°C (104°F).
- The rack and all mounted equipment in it must be reliably grounded according to naonal and/or local
electrical standards.
4.2
4.3
Dismantling front handles of the device could invalidate warranty on aer-sales services of
your Eikos². It is strongly advised to avoid using front handles as rests for your Eikos², they are
designed for manipulaon purposes only.
If required, front handles of the device can be dismantled, but with cauon. The original screws removed
must not be reintroduced to their locaon without handles in place. Substanal damages can occur,
including risk of electric shock from the main voltage. Only M4x12mm screws can be used. They are
supplied with the unit.