User Manual


4.2 Unpacking and inspecon
• 1 x 
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x Web-based Remote Control Soware included and hosted on the device
• 1 x Rack mount kit
• 1 x User manual (PDF version)*
• 1 x Quick start guide*
* User manual and Quick start guide are also available on www.analogway.com
Before racking and plugging any inputs and outputs, it is advised to power on the unit. Should you encounter
any issue, you must contact immediately your local distributor or dealer, or closest  technical
support oces (see chapter: 14. Contact informaon).
 The  can be used directly on a table; the unit is equipped with 4 handy an-
slip rubber feet.
 The  is compable with a 19” enclosure. Please follow the instrucons below to
install the device in a 19” rack.
 The  weighs 30.86LBS (14Kg). Please provide appropriate support to the frame during
installaon. First, place ears on each side of the device (ref: 180469) Place the device in your rack. Aach the
device to the rack by using 2 screws through the ears (screws not included).
Addional support, such as the rear rack support or slide rails, is required. The  is equipped with
drill holes designed for compability with rack mount (ref: 180489). Use 4 screws M4x10 countersinck on
both sides of the unit. Adjust the size of the rail in order to ll your rack.
A lacing bar is provided with the rack mount kit (ref: 180489). Install it with the M4x10 screws according to
your cables posion.
Connect all of the cables to the device and aach them to the lacing bar with the help of e wraps.

- The openings in the front and rear panels of the device are for cooling. Air ows from front to back. Do not
cover these openings to avoid cung air circulaon.
- The maximum ambient operang temperature should not exceed 40°C (104°F).
- The rack and all mounted equipment in it must be reliably grounded according to naonal and/or local
electrical standards.
 
 
Dismantling front handles of the device could invalidate warranty on aer-sales services of your
. It is strongly advised to avoid using front handles as rests for your , they
are designed for manipulaon purposes only.
If required, front handles of the device can be dismantled, but with cauon. The original screws removed
can be reintroduced to their locaon without handles in place. Substanal damages can occur, including
risk of electric shock from the main voltage. Only M4x12mm screws can be used. They are supplied with
the unit.

Mounng using only the front
rack ears is sucient for xed
installaons. Addional support,
such as the rear rack support or
slide rails, is required for mobile
applicaons, and recommended
for all.