User Manual

Ref. NXT1604

Thank you for choosing  and the . By following these simple steps, you will be able to
set up and use your Powerful true-seamless AV processor based on ’s new LiveCore™ plaorm
within minutes. Discover the  capabilies and intuive interface while commanding top-notch
presentaons and unleash your creavity for a new experience in show and event management.
• 1 x 
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x MCO 10 pin connector
• 1 x Web-based Remote Control Soware included and hosted on the device
• 1 x Rack mount kit
• 1 x User manual (PDF version)*
• 1 x Quick start guide*
* User manual and quick start guide are also available on www.analogway.com



The   uses standard ethernet LAN
networking. To connect the Web RCS to your new
, you rst need to connect a computer
to the  using the Ethernet cable. Then
on your computer open an internet browser which
supports Flash® player.
Into this internet browser, please enter the IP
address of the  displaying on the front
panel screen.
The connecon should start.
Oen, computers are set to DHCP client (automac
IP detecon) mode. You may need to change the
IP address conguraon on your computer before
you can connect. These sengs are found in the
properes for your LAN network adaptor, and vary
by operang system.
The default IP address on the   is
 with a netmask of 
Therefore, you can assign your computer a stac
IP address of  and a netmask of
 and should be able to connect.
If the connecon is not starng, please see:
• Be sure the computer IP address is on the same
network and subnet as the .
• Be sure that no two devices have the same IP
address (prevent IP conicts)
• Check your network cable. You will need a
crossover ethernet cable if you are connecng
directly from the  to the computer. If
a hub or switch is involved, use straight ethernet
cables.
• For more informaon, please see the user manual
or contact your local technical support.
Once you have successfully connected, the ash
app will automacally download and launch in your
browser. When the two icons in the boom right
corner of the screen turn green, the Web RCS is
ready to use. If you are having trouble syncronizing,
try clearing the cache and refreshing the page
(ctrl+F5 in most browsers):
-  will turn green when connected
-  will turn green when the Web RCS has
nished syncronizing.

Mounng using only the front
rack ears is sucient for xed
installaons. Addional support,
such as the rear rack support or
slide rails, is required for mobile
applicaons, and recommended
for all.