User guide
1/ In the MENU section, press the [EXIT/MENU] button and select
Input in the menu by rotating the scroll knob. Then press the
[ENTER] button to enter the Input sub-menu.
2/ In the Input menu, select the type of input you have plugged into
the PLS300 by rotating the scroll knob (see Input Specications).
Then press the [ENTER] button to enter the types of inputs
connected to the PLS300.
3/ Press the [EXIT/MENU] button to return to the main menu.
4/ Repeat steps #1 to #3 for every source connected to your PLS300.
Once your inputs have all been congured, the output settings of
the PLS300 must be set according to the machines plugged on
your PLS300 main and preview outputs (video projector, preview
monitor...).
* NOTE * : It is strongly recommended to set the output format of
the PLS300 to match the native resolution of the display devices
connected to the PLS300.
1/ In the Menu section, press the [EXIT/MENU] button and select
Output in the menu by rotating the scroll knob. Then press the
[ENTER] button to enter the Output sub-menu.
2/ In the Output menu, select the output type, resolution and frequency,
to match the viewing hardware plugged into the PLS300, by
rotating the scroll knob (see also Output Specications). Then
press the [ENTER] button to enter each of the output parameters.
* NOTE * : be sure to press the [ENTER] button to conrm every
selected setting, the PLS300, will revert to its original settings if new
choices are not conrmed.
3/ Press the [EXIT/MENU] button to return to the main menu.
Input selection settings
Source output selection
Output selection settings
28