Owner's manual

REMOTE CONTROL SOFTWARE
Your device is shipped with a Windows compatible Remote Control Software. This software allows you to control and
make all adjustments by a simple mouse click.
NOTE : Preferably use Windows NT, 2000 or XP for LAN operation.
① CONNECTING TO THE RS232 PORT :
 -ConnecttheserialportofyourcontroldevicetotheRS232port(DB9Femaleconnector)ofthedevicewitha
straightcable(DB9Female/DB9Male).
- Speed transmission :9600bauds,8databits,1stopbit,noparitybit,noowcontrol.
- Pin-out :
PIN # FUNCTIONS
    2  TRANSMITDATA(Tx)
3 RECEIVE DATA (Rx)
    5  GROUND(Gnd)
② CONNECTING TO THE LAN PORT :
 -ConnecttheLANport(RJ45connector)ofthedevicetoyournetworkaccordingtoyourinstallation.
① TurnyourcomputerONandwaitforWindowstocompletelystart.
② InserttheCD-ROMintoyourdrive:theANALOGWAYhomewindowwillopenautomatically.
③ SelectthelanguageoftheCD-ROMmenus,thenclickon“InstallaRemoteControlSoftware”andselectthe
name of your device.
IMPORTANT : If the Autorun is not enabled : From the Windows desktop, open My Computer and select the
CD-ROM drive. Select the Autorun folder, and then select the autorun.exe le.
④ Follow the Windows installation instructions.
7-1. CONNECTIONS
7-2. SOFTWARE INSTALLATION
7-3. COMMUNICATION SETUP
DB9female(Rear
panel of the device)
① ConnecttheRS232orRJ45cablebetweenthedeviceandthecontroldeviceasindicatedinthesection7-1.
② ThenpowerONallofthedevices.
③ ClickontheprogramlesOctoValueinStart>program>ANALOGWAY>OctoValuetorunthesoftware.
④ ClickonControlmenuandselectRS232/LANsetup,then:
• CASE OF RS232 PORT :
 -Withthefrontpaneldisplaymenuofthedevice,verifythattheRS232portisactivated(CONTROL>RS232/
LANport>RS232).
 -WiththeControlmenuofthesoftware,selectRS232/LANsetup,thenselectRS232andselecttheCOMport
numbercorrespondingtotheconnectionofthedeviceinthePorteld.
If the communication is OK, the message
"Device connected" is displayed as well as the
model in the windows title bar.
PAGE 38