X Instruction Manual

7.2.4 Misc

PRESET TOGGLE: by default, the device will not swap the Program and

Preview busses during each TAKE. Disabling this opon will leave the

Preview bus unchanged during each TAKE, and only the Program will be

updated. When this opon is enabled, the Preview and Program busses will

be swapped during each TAKE.

AUTOTAKE: enable the automac TAKE. Each me a source is changed on

preview, it triggers a TAKE to be launched.

DYNAMIC FIT: enable or disable the automac recognion of black band for

digital content. The size and the aspect rao of the layer are automacally

adapted.

FREEZE MODE: choose to freeze all inputs or only one input when you use the freeze funcon.

PIP BACKGROUND COLOR: here you chose the automac color of PIP background, black is the default color.

A short summary of each output sengs

appears on the main page. You can see the

number of outputs, their resoluon, rate and

HDCP status.

Select an output to adjust by either clicking on

it from the column on the le, or clicking the

conguraon cog icon for that output.

Once the individual output setup page is

opened, you have access to:

 choose your rate generaon mode,

internal (free-running within the unit) or

Framelock by choosing an input as a reference

input,

- FORMAT: choose the output resoluon

format,

- RATE: choose the signal ming standards, if

the mode is set to internal

- STATUS: the status menu will show you the current output status,

- APPLY: click on this buon to apply the new format/rate,

- PLUG STATUS: indicates the status of the aached monitor and conrms connecvity,

- TYPE: you can choose the type of output synchronizaon on the analog plug, for example RGsB for sync on

green, or RGBHV for separate H and V sync wires,

Into the output secon, you will be able to manage your output resoluons, formats, sync types, test paerns,

etc. On the SETUP > OUTPUT TAB, the following screen will appear:

