X Instruction Manual

31
In this case, you can enter manually into each input sengs by using the le menu:
Under the SIGNAL tab, you will nd:
- ACTIVE PLUG: select the plug used by the unit at the moment.
Only this plug can be displayed on your output,
- SETUP PLUG: select the plug you want to set up, all changes will
be applied to this plug, even if this plug is acve or not (do not
mismatch with the acve plug),
- SIGNAL TYPE: dene the type of your signal, video SD/HD YUV/
RGB or Computer HV/SOG etc.,
- ENABLE: enable/disable the input,
 aect the input to the ref sync input. Use this box
only if your source is genlocked with the referenced source
(framelock feature),
- LABEL: rename your input according to your source,
- AUDIO MAPPING: select the audio input that will be linked with
the video input,
- EMBEDDED SIGNAL AUDIO: status indicates if an embedded
audio signal is detected or not,
- STATUS: format and size of the input,
- CONTROL: Black: select Black to transform your input in a uniform color,
 use this buon to freeze the specic input,
- EDID: choose the EDID for the selected plug.
Under the HDCP secon, you can:
- Enable/disable the HDCP communicaon feature
- Read the HDCP status, If the HDCP status says Acve, this output connecon is currently ulizing HDCP to
protect the signal. if the HDCP status indicates Idle, this output connecon is currrently not ulizing HDCP.
Next is the IMAGE tab, where you can nd all sengs about the display of your input:
Under the COLORIMETRY secon, you have:
- LEVEL: dene the selected input luminosity level,
- CONTRAST: dene the selected input contrast level,
- COLOR: dene the selected input color level (0:black and white, full: full color),
- HUE: set up the hue phase of your NTSC signal.
7.2.6 Input management