Manual

RKD8044-T

PAGE 7

2-2. REAR PANEL

ON / OFF: AC Power switch (O = OFF, I = ON).

POWER INPUT: Standard IEC connector (100-250 VAC, 50-60Hz automatic).

RS-232: RS-232 connector (DB9 M) for connecting the Diventix 2

LAN: RJ 45 connector for connecting the Diventix 2 (cross cable) or to LAN (Direct cable)

Chapter 3 : CONNECTING THE RKD8044-T

3-1. RS-232

Connect the RS-232 connector of your switcher to the RS-232 connector of the RKD8044-T with the supplied

REMOTE cable.

Connect the AC power supply cord to the RKD8044-T.

Power "ON" the Remote Control Unit with the power switch (rear panel).

Turn ON all of your sources, the switchers, the projectors, and the local monitors.

NOTE: Always set the T-BAR to the bottom position before switching ON or OFF the RKD8044-T.

3-2. LAN

Connect the LAN port (RJ45 connector) to your network according to your installation

Setup the LAN parameters of the RKD8044 in UDP mode using LCD menu “Control”-“LAN Setup”-“UDP”.

Sum up of the example TCP/IP addresses in UDP mode:

PRODUCT Local Address Remote Address

Local

Port

Remote

Port

Gateway

Address

Netmask

DVX8044

192.168.000.010 192.168.000.255 10500 10500 192.168.000.001 255.255.255.000

RKD8044-T

192.168.000.002 192.168.000.010 10500 10500 192.168.000.001 255.255.255.000