User`s manual

Chapter 1 : INTRODUCTION (continued) SCAN 1600 / DIGI SCAN 1600
PAGE 10
1-7. DIGI SCAN 1600 FRONT PANEL DESCRIPTION
DIGI SCAN 1600
ANALOG WAY
R
MENU CONTROL
 Allows to scroll thru the different menus.
ENTER: Validates a selected item.
A long push on this button allows to activate the STANDBY mode. A short push on this
push button allows to wake up the device.
EXIT MENU: Allows to exit from a LCD menu.
ADJUSTMENTS
POS. SIZE: Position or Size mode selection.
H: Horizontal image adjustment.
V: Vertical image adjustment.
ZOOM: Zoom mode selection (long push)
FREEZE: Freezes the displayed output (short push).
1-8. DIGI SCAN 1600 REAR PANEL DESCRIPTION
ON / OFF: AC power switch (O = OFF, I = ON).
POWER: Standard IEC connector (100-250 VAC, 0.5A, 50-60Hz automatic).
RS-232: RS-232 communication port on a DB9 female connector.
INPUT & MONITOR
COMPUTER INPUT: Analog computer input on HD15 female connector.
DVI-D INPUT: DVI-D computer input on DVI female connector.
RGB Hi-Z / 75 : RGB input load. Set this button on Hi-Z if you connect a monitor on the MONITOR OUT
connector. If not set it on 75 .
MONITOR OUTPUT: Analog computer output (loop-through) on HD15 female connector.
GENLOCK
IN: GENLOCK input.
OUT: GENLOCK output (loop-through).
VIDEO OUTPUTS
R, G, B, S: RGB/S or RGsB video outputs (on 3 or 4 BNC connectors).
Cr, Y, Cb: Component video (YUV) output (on 3 BNC connectors).
PAL/NTSC: Composite video output (on 1 BNC connector).
SDI: SD-SDI (4:2:2) output (on 1 BNC connector).
S.VIDEO: S.VIDEO output (4-pin mini DIN connector).