User`s manual

SCAN 1600 / DIGI SCAN 1600
PAGE 12
Chapter 2 : STARTING
2-1. DIGI SCAN 1600 CONNECTIONS:
c Turn OFF all of your equipment before connecting.
d Connect the AC power supply cord to the DIGI SCAN 1600 and to an AC power outlet.
e Connect your computer source to the COMPUTER INPUT (HD15) connector or the DVI-D INPUT connector.
f As required, connect a control monitor on the MONITOR OUT (HD15) connector.
NOTE
: Set the RGB Hi-Z/75 Ω button on Hi-Z if you connect a monitor on the MONITOR OUT connector. If not set
it on 75 Ω.
NOTE:
The MONITOR OUT is available only if the COMPUTER source is analog.
g Connect your display devices (TV monitor, VCR...) to the outputs (analog or SDI).
h Turn ON the DIGI SCAN 1600 (rear panel switch). Then turn ON your input source and then your display devices.
• DIGI SCAN 1600 connection diagram:
2
6
Ω
3
4
5
5
• RGB/COMPONENT output connection: