User`s manual

ManualsBrandsAnalog way ManualsMedia ConverterScan 1600

SCAN 1600 / DIGI SCAN 1600 Chapter 3 : FRONT PANEL DISPLAY MENU DESCRIPTION (continued)

PAGE 17

3-5. FUNCTIONS DESCRIPTION (continued)

3 [IMAGE] + ENTER.

3-1 [Flicker filter] + ENTER.

Select one of the 8 levels of the anti-flicker with  and validate with ENTER.

3-2 [Black Level] + ENTER. (Available for analog input source only).

Adjust the Black level with  + ENTER.

3-3 [RGB Levels] + ENTER. (Available for analog input source only).

Select an item with  + ENTER.

• [Red] : Adjust the level of the Red with  + ENTER.

• [Green] : Adjust the level of the Green with  + ENTER.

• [Blue] : Adjust the level of the Blue with  + ENTER.

3-4 [H. smooth] + ENTER. (Available for the analog input source only).

Select an item with  + ENTER.

• [ON] : Active the horizontal filter.

• [OFF] : Inactive the horizontal filter.

3-5 [Position status] + ENTER.

Displays the image position status.

3-6 [Under/over] + ENTER.

Select an item with  + ENTER.

• [underscan] : The output image is full screen.

• [overscan] : The output is 10% bigger than in underscan mode.

3-7 [Zoom status] + ENTER.

Displays the image zoom status.

3-8 [Preset] + ENTER.

This function allows to set all the image parameters (flicker filter, Black level, RGB level, under/overscan,

position & size) to the factory settings.

FUNCTION POSITION FUNCTION POSITION

3-1 Flicker Filter level 1. 3-4 H smooth off.

3-2 Black level. 0 3-6 under/over underscan.

3-3 RGB levels. 0 Position & size 0

4 [CONTROL] + ENTER.

4-1 [Panel locking] + ENTER.

This function allows to lock the front panel buttons. Select an item with  + ENTER.

• [lock] : allows to lock the front panel push button.

• [unlock] : doesn't lock the front panel button.

NOTE:

To unlock push simultaneously on ENTER and EXIT.

4-2 [Version] + ENTER.

Status of the internal firmware.

4-3 [Erase memories] + ENTER.

This function allows to erase all the image settings memorized.

4-4 [Default value] + ENTER.

This function allows to clear the following adjustments and set them to the factory value:

FUNCTION POSITION FUNCTION POSITION

1-2 Input type analog 2-2 Output standard NTSC

1-3 SOG input no. 2-3 Output rate internal.

1-4 H sync load Hi-Z. 2-4 RGB/YUV out YUV

1-5 Genlock load Hi-Z. 2-5 test pattern no.

1-6 Genlock H Ph 0 4-1 panel locking unlock.

1-7 Genlock Sc. Ph. 0