User guide

05/16/2014 - SPU001-QSG

Code: 140156

This Analog Way product has a 1 year warranty on parts and labor (except for the power supply, the frame

head and the baery that are under warranty only in case of “Dead On Arrival”). This warranty does not

include faults resulng from user negligence, special modicaons, electrical surges, abuse (drop/crush),

and/or other unusual damage. In the unlikely event of a malfuncon, please contact your local Analog Way

oce for service.

Hot swap:

You may wish to replace defecve elements while the installaon is running.

To replace a defecve power supply unit while the LiveCore™ device is running, follow these steps (taking the

usual safety measures against ESD):

• Unplug the power cable from the mains,

• Unplug the power cable from the defecve Power Supply Unit and take it o,

• Fit the new Power Supply Unit,

• Plug the IEC power cable to the Power Supply Unit,

• Connect the power cable to the mains.

To replace the baery, put the LiveCore™ device in stand-by, replace the baery then turn on the LiveCore™

device.

WARRANTY AND SERVICE

The third step is to connect the Secure Power Unit to the

LiveCore™ through an RS232 cable. It will provide informaon

about the Secure Power Unit directly on the Web RCS

interface. Connect the ground between the Secure Power

Unit and the LiveCore™ device.

The last step is to power the Secure Power Unit. The LiveCore™

device is ready to run safely.

WARNING: In order to power the Secure Power Unit, plug IEC

cables rst in the Secure Power Unit then plug into the mains

power.

STEP #3 STEP #4