Manual

The applicaon tries to detect and connect
the Shot Box. It may take a few seconds for the
applicaon to succeed. In case of failure, Shot
Box for LiveCore™ series indicates an error and
will aempt to reestablish a new connecon with
the device once every 3 seconds. When detected,
the applicaon indicates the type of Shot Box
connected and let you adjust the LED backlight
intensity.
Enter the IP address of the Analog Way LiveCore™
Switcher you want to connect as well as the
corresponding TCP port number (default is 10600).
If you intend to use the Shot Box for recalling Master Presets, make sure to select the
opon Master Presets. However, if you intend to use the Shot Box for recalling Screen
Presets, make sure to select the opon Screen Presets and then choose the corresponding
screen index (from 1 to 8 depending on your conguraon).
When ready, click Connect to aempt a connecon to the remote host. Make sure
your rewall is opened for the entered port number. If the connecon is successful, the
applicaon displays Connected and ready as well as the type of LiveCore™ Switcher
detected. The green LED indicator in the upper-le corner is enabled. In case of failure,
Shot Box for LiveCore™ series displays an error message and the LED indicator in the
top-le corner blinks red.
If you would like for Shot Box for LiveCore™ series to start each me your system starts,
you can check the box Open the applicaon automacally on Startup.
If you would like for Shot Box for LiveCore™ series to connect automacally the
LiveCore™ Switcher each me the applicaon starts or when it gets disconnected, you
can check the box Automacally connect or reconnect the LiveCore™ device.
If you would like for Shot Box for LiveCore™ series to start minimized to tray, you can
check the box Start minimized to tray.
If you need to reboot (turn o and turn back on) the LiveCore™ Switcher remotely, simply
click Restart. If you want to turn it o, choose Shutdown. In this case the LiveCore™
Switcher will have to be restarted manually. If you would like for the LiveCore™ Switcher
to shutdown with Wake-On-Lan feature enabled, click Shutdown with WOL. In this
mode, you will be able to power up the LiveCore™ Switcher from your network remotely
by clicking the WOL buon (WOL feature requires LiveCore™ rmware 1.04.x or above).
To terminate the program, choose Quit in the context menu of the
system tray entry.