User guide
49
5-2. WORKING WITH THE RCS
Once your STE100 is wired up to your PC, the
rst step in properly conguring your machine is to
individually select and parameter your inputs.
Click on the “Inputs” tab of the RCS.
In the Plug column of the “Input” page, select the
plug type by clicking the appropriate eld.
Activate the input in the Enabled column if it
is not.
In the scroll-down menu of the Type column,
select the signal type connected to that plug.
Repeat steps 2 to 4 for all sources connected to
the rear panel of your STE100.
Click on the “Inputs” tab to return to the main screen.
* NOTE *: Autosetting mode allows an easy setup of sources. Sometimes problems might appears with
analog or HDCP sources.
Click on the “Outputs” tab of the RCS.
Select the type of plug which is connected to
outputs #1 & #2 of your STE100 by clicking in
the appropriate eld in Analog Type or DVI Type
for both Main and Preview outputs.
Select the appropriate output format and output
rate.
Click on the “Outputs” tab to return to the main
screen.
The Output menu also allows you to generate test patterns. The test patterns available through the Output
menu let you quickly and reliably setup your projectors.
* NOTE *: Be sure to turn the test pattern off to display your sources again.
Source input conguration
Source output conguration
1.
1.
2.
2.
3.
3.
4.
4.
5.
6.