Quick Guide

- 16 -
2.3.1 Apple Airport Remote Access Setup
In order to access the camera remotely from outside your network, you have to tell your Airport to allow access to
the network ports used by the camera.This is called “port setting” and is done with Airport utility as follows:
In the Airport Utility version 6.3.1, go to manual setup and select the “Network”
icon. 1. Click on the + (add) button below the “port setting”.
2. then click on the +(add) icon at the bottom of the box , and enter the following info:
Public UDP port: 30000-30001 (next camera would have 30002-30003 etc)
Public TCP port: 8150 (your 2
nd
camera would have 8151 here, 3
rd
8152
etc) Private IP address: (add the IP address for your camera, e.g.
10.0.1.201) Private UDP port: 30000-30001 (same as public UDP port)
Private TCP port: 80
3. Then click on “save” , “Update” and “Continue” to restart your airport.
Now some from the outside your network should be able to access your camera using your external IP address with:
8150 added to the end. For example, if the Airport summary screen shows your IP address as 192.168.168.120, you
would enter the following in your browser: http://192.168.168.120:8150.