Quick Guide

- 75 -
5.8.4.5 Record to Storage on Alarm/ Record to Storage Continuously
[Enable] Enable task.
[Schedule] Option to choose always or set a particular schedule. Check Schedule setup to select the right schedule
ID for your task.
[Task] Task function. Click on the task to login the task setting screen below.
Click Apply to confirm your setting
1.
[Record from]-- Select the stream from which it should record. It can be “Primary stream” , “Secondary stream”
and “ Mobile Stream” . For smaller pictures you can select from “Secondary stream” or “Mobile Stream”.
2. [Post-recording time]--The number of seconds that the camera should keep recording video after motion stops.
If there is any motion within this time the camera will keep recording until there is no motion for the duration of
this parameter. It can be from 5 seconds to 24 hours.
3. [Split duration]-- This specifies the maximum duration of one file. If the recording goes on for longer than this
parameter the camera will split the video into a number of files.
4. [Record thumbnail]-- Enable or disable thumbnail.
5. [Image file name] --Name of file image snap shots are saved to
6. [Suffix of file name]-- Choose between Sequence number and Date
7. Click Apply to confirm your settings.
Instead of using motion detection (Record to Storage on Alarm), you can also use the “Record to storage continuously”
menu to record video at 24 hours or as per your schedule.
5.8.4.6 Send files in storage to FTP server
[Enable] Enable task.
[Schedule] Option to choose always or set a particular schedule. Check Schedule setup to select the right schedule