Instructions for Use
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer
- Visit our website at
- For Technical Assistance, send us email at
- One-Year Limited Warranty
- Safety Information
- Table of Contents
- 1Using This Manual
- 2Introductions
- 3Getting Started
- 4.Vehicle Identification
- 5Diagnostic Operations
- 6Steering Angle Sensor (SAS) Calibration
- 7OBDII/EOBD Operations
- 8System Setup
- 9Update
17
AD610 Plus ABS & Airbag Reset Tool Manual_English_V1.02
1.
Refer to step 1-3 of 4.2.1 SmartVIN.
2.
On each screen that appears, select the correct option and then press the ENTER key. Do this until
the complete vehicle information is entered and the menu of controller selectiondisplays.
Figure 4-15 Sample Manual Vehicle Selection Screen
5
Diagnostic Operations
This section illustrates how to use the scanner to read and clear diagnostic trouble codes, and view
“live” data readings and ECU information on controllers installed on a variety of vehicles and also
save “recordings” of the data readings.
5.1 Control Module Selection
When you completed the identification of vehicle, you have to identify the control modules installed in
the vehicle. There are two ways to identify the controllers installed in a car:
● Quick Scan
● Control Modules
5.1.1 Quick Scan
Quick Scan performs an automatic system test to determine which control modules are installed on
the vehicle and provides diagnostic trouble codes (DTCs) overview. Depending on the number of
control modules, it may take 10 minutes or longer to complete the test.
To perform an automatic system scan:
1.
Scroll with the arrow keys to highlight Quick Scan from the menu and press ENTER to start.
Figure 5-1 Sample Main Group Screen
2.
To pause the scan, press the function key corresponding with Pause on the screen.