Instructions for Use

27
AD610 Plus ABS & Airbag Reset Tool Manual_English_V1.02
IMPORTANT
Before bleeding the brake system, make sure no diagnostic codes are present.
Do not let the master cylinder run dry during the brake bleeding procedure.
After bleeding the brake system, check the brake pedal for excessive travel or a “spongy” feel. Bleed
again if either condition is present.
● Automated Test - automatically commands each solenoid valve and the pump motor on and off
to test for proper operation.
● Brake Bleed Preparation Test - prepares the brake lines for bleeding by clearing air from the
modulator. The test rehomes all the ABS and TCS motors, cycles the TCS motors, and then
returns all motors to the “home” position at the bottom of thebore.
● Function Test - automatically commands the ABS relay, valve solenoids, and pump motor on and
off to test for proper operation.
● Gear Tension Relief Test - relieves tension from the ABS motor gears so you can separate the
ABS motor pack from the ABS hydraulicmodulator.
●
Hydraulic Control Tests - allows to manually engage and disengage the ABS solenoids for
troubleshooting the hydraulic functions.
●
Idle Up Manual Control Test - allows to manually control the idle upactuators.
●
Lamp Tests - allows to manually control the ABS or TCS warning or indicator lamps.
●
Motor Rehome Test - prepares the brake lines for bleeding by clearing air from the modulator.
The test returns all ABS motors to their “home”positions.
●
Pump Motor Tests - allows to manually control the pump motor.
●
Relay Test - allows to manually engage and disengage either the ABS or TCS relays in order to
test relay operation.
● Requested Torque Test - allows to manually control the engine torque to test for proper
operation of the traction control system (TCS).
●
Setup SDM Serial Number (Air Bag Sensing and Diagnostic Module) - allows to program a
new air bag serial number into the dash integration module (DIM). You use this test after installing
a new air bag; otherwise a diagnostic trouble code will be set when you turn on the ignition.
● Solenoid Tests - allows to manually control the inlet and output valvesolenoids.
● System Identification - displays information about the brake system, the vehicle, and the ABS
controller.
●
TCS Test - allows to control the pump motor in order to apply fluid pressure to the front wheel
circuits.
●
Traction Control System (TCS) Manual Control Tests - allows to perform motor tests and an
adjuster assembly control test.
● Voltage Load Test - “loads” the ABS battery supply circuit to test for adequate battery capacity.
To perform special tests on a vehicle:
1. Scroll with the arrow keys to highlight the special function test you want to perform from the menu
and press the ENTER key.