Instructions for Use
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer
- Visit our website at
- For Technical Assistance, send us email at
- One-Year Limited Warranty
- Safety Information
- Table of Contents
- 1Using This Manual
- 2Introductions
- 3Getting Started
- 4.Vehicle Identification
- 5Diagnostic Operations
- 6Steering Angle Sensor (SAS) Calibration
- 7OBDII/EOBD Operations
- 8System Setup
- 9Update
9
AD610 Plus ABS & Airbag Reset Tool Manual_English_V1.02
print data.
4 Nylon Carry Pouch - stores the scanner and its accessories.
2.3 Technical Specifications
Display: Back lit, 240*320 TFT color display
Working Temperature: 0 to 60
℃
(32 to 140
℉
)
Storage Temperature: -20 to 70℃(-4 to 158℉)
Power Supply: 8-18V vehicle power and 3.3V USB power
Dimensions: (L*W*H): 200*100*38mm
Weight: 0.6 Kg
3
Getting Started
This section describes how to provide power to the scanner, provides brief introductions of
applications loaded on the scanner and display screen layout and illustrates how to input text and
numbers with the scan tool.
3.1 Providing Power to Scanner
Before using the scanner, make sure to provide power to the scanner.
The unit operates on any of the following sources:
● 12-volt vehicle power
● USB connection to computer
3.1.1 Connecting to Vehicle Power
The scanner normally powers on whenever it is connected to the data link connector (DLC).
To connect to vehicle power:
1.
Locate the data link connector (DLC). The DLC is generally located under the dash on the driver
side of the vehicle.
2.
Attached the Diagnostic cable to the scanner and tighten the captive screws to ensure good
connection.
3.
Connect a correct adapter to the data cable according to the vehicle being serviced and plug it into
the vehicle DLC.
4.
Switch the ignition key to the ON position.
5.
The scanner automatically boots up.
IMPORTANT
Never try to provide power for the scan tool from USB connection when the scan tool is
communicating with a vehicle.
3.1.2 Connecting to Computer with USB Cable
The scan tool also receives power through the USB port when it is connected to a computer for
software updates and printing of data.
To connect to computer:
1. Connect the scanner to a computer with the USB cable provided.
3.2 Application Overview
When the scan tool boots up, the Home screen opens. This screen shows all applications loaded on
the unit. The available vehicle applications may vary depending on software configuration.
● Auto VIN - leads to screens for identifying a car by VIN reading.
●
OBDII/EOBD - leads to OBDII screens for all 9 generic OBD system tests.
●
SAS - leads to screens for steering angle calibration