Instruction Manual

MADE IN USA
SIX YEAR WARRANTY
Go Getter Sound System Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
MIC 2
VOLUME
MIC 1
VOLUME
TREBLE
ON
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
POWER JACK
POWER/LOW BATTERY
LINE OUT
LINE IN
LINE IN
MIC 1 MIC 2
LINE IN
VOLUME
SPEAKER OUT
VOLUME
VOLUME
BASS
POWER
Go Getter
www.anchoraudio.com
2
BACK PANEL OF GG-U2 (AC/DC)
BASIC SYSTEM OPERATION
NOTE: Fully Charge Batteries Before First Use!
IMPORTANT: Make all connections with shielded
cables to avoid hum, buzzing or interference.
1. Set all Input Level Controls to minimum
& Tones Controls to flat or the middle
setting before turning your system on
2. Plug a wired microphone into the MIC
1 or MIC 2 jacks and/or plug an audio
source into the LINE-IN jack
3. Switch POWER to ON, the BATTERY LED
will light
4. Slowly increase the Level Control for the
input jacks used to the desired volume
5. Adjust BASS & TREBLE controls to
desired sound quality
WIRELESS RECEIVERS 4
(see page 6)
POWER SWITCH
LINE IN - INPUT JACKS
The 1/8” (3.5 mm) jack
input is used to hook up an
iPod, a portable CD/ MP3/
tape player, laptop com-
puter, or similar external
audio source
The 1/4” unbalanced input
can be used for other
communication devices
including a mixer or daisy
chaining together multiple
Go Getter speakers
SPEAKER OUT -
OUTPUT JACK
Connect the system to a Go
Getter unpowered companion
speaker
CHARGE INDICATOR LIGHT
LINE IN LEVEL CONTROL
BATTERY LEVEL
INDICATOR LIGHT
TONE CONTROLS - BASS/TREBLE
WIRED MIC LEVEL CONTROLS
WIRED MIC INPUTS
LINE OUT - OUTPUT JACK
Balanced 1/4” – provides a combined
output of all active system inputs
Record your presentation or connect to
another powered sound system
RX INDICATOR LIGHTS FOR
WIRELESS RECEIVER 1
A solid red light on one of the
RX Indicator Lights indicates
that the sound system is getting
good reception with the wireless
microphone
A solid red light on both RX
Indicator Lights indicates that
the sound system is a optimum
reception with the wireless
microphone
WIRELESS MICROPHONE 1
LEVEL CONTROL
Adjust knob to control
wireless microphone levels
WIRELESS MICROPHONE 2
LEVEL CONTROL
SPEAKER STAND SETUP
1. Loosen the Lower Collar Knob
2. Separate the stand legs until the leg support Cross
Braces are parallel to the floor
3. Tighten the Lower Collar Knob
4. Loosen the Upper Collar Knob and extend the
center pole
5. Adjust height and retighten the Upper Collar Knob
6. Place your Anchor sound system on the stand
SPEAKER STAND ADAPTER
The 1.5” diameter Speaker Stand
Adapter lets you mount the Go
Getter on a speaker stand.
LOWER
COLLAR
KNOB
UPPER
COLLAR
KNOB
CROSS BRACES
1. Slide Speaker Stand Adapter
into slot on Go Getter bottom
2. Tighten screw to secure
adapter
3. Place unit on stand carefully
4. Tighten screw on Adapter
collar securing Go Getter on
stand
RX INDICATOR LIGHTS FOR
WIRELESS RECEIVER 2