Water Filters ANCHOR pure water in every drop MODEL RO 5, RO 5 WITH PUMP AND RO 6 INSTRUCTIONS MANUAL Treat your body to pure goodness with Anchor filtered water
A Water supply adapter valve H Prefilter sump B Cold water shut-off valve J Pre-carbon filter sumps C Hot water shut-off valve K User friendly wrench D Auxiliary faucet with handle in closed position L Membrane assembly E Garbage disposal M Auto shut-off valve F Drain Saddle N Post-filter G Storage tank with valve in open position TAPPING INTO THE COLD WATER LINE (Using the water supply adapter model SV-1) NOTE: The drinking water system must be connected to the COLD water supply only.
1) Disconnect the threaded nut at the connection and thread the water supply adapter, with the flat washer in place, onto the connection and tighten. Connect the green tubing to the water supply adapter with the treaded nut and tighten. 2) Thread the needle valve into the adapter tightly and turn the handle clockwise all the way in. Turn on cold water supply to the sink faucet and check for leaks.
DRAIN CLAMP INSTALLATION POSITIONING THE SYSTEM 1) The drain clamp assembly should be installed above the trap and on the vertical or horizontal tailpiece (Fig. #5) 1) The head assembly will stand up in the sink cabinet or can be hung on screws provided. 2) The storage tan k may be laid on its side. 3)The head assembly and/or storage tank maybe placed up to 15 feet from the point of use with nominal pressure loss.
START-UP PROCEDURE 1) Check to see all connections are made. 2) Check that the pre-filter and pre-carbon sumps are secure using the housing wrench provided. 3) Slowly turn on the water by turning the needle valve counterclockwise. 4) The valve handle on top of the tank should be in the open position, parallel to the valve body. 5) The handle of the faucet should be perpendicular to the spigot (closed). 6) Check for leaks.
CHANGING THE MEMBRANE Replacement TFC membranes come with complete changing instructions when ordered. TROUBLESHOOTING LEAKS 1) Filter sump: The O-ring in the sump may not be making firm contact, have dirt or hair on it or be stretched. Clean or replace O-ring and tighten sump to make firm contact with cap. 2) Fitting Connection: Compression - Check that the fitting is tightened with all parts in proper place (refer to Fig. #8).
