Instructions / Assembly

1) Position the drain saddle valve at selected
location and mark for the opening.
2) Drill ¼-inch (6.3mm) hole at mark through
one side of pipe.
3) Remove backing from gasket and place
adhesive side to the fitting half of drain
clamp around hole.
4) Position both halves of drain saddle on
drainpipe so the opening aligns with drilled
hole. Use a small drill bit to verify that drain
clamp is properly aligned.
5) Secure drain saddle clamp on valve with
bolts and nuts provided. (Do not over
tighten, and make sure there is equal space
between saddle halves on each side.)
Mount
Drain
Saddle
Valve at
either
location
Warning!!
Never
Mount
Drain
Saddle
Valve here
5. Mounting the Drain Saddle Valve
Drain Saddle Valve is used to make wastewater connection with the
drain under the sink and is designed to fit standard 1 1/2-inch OD
drainpipe. The drain saddle valve should always be installed before
(above) the p-trap and on a vertical or horizontal drain. To avoid
clogging the drain line with debris, do not install the drain saddle near
a garbage disposal. See below.
Fig 2. Drain
Saddle Valve
Fig 3. Flow Restrictor