Instructions / Assembly

4) Place the storage tank in the desired location. Since it is a pressure
storage tank, it can stand up straight or lie down.
5) Connect the other end of yellow tubing from the tank ball valve to
inline post-carbon filter (5th stage).
6) Turn the tank ball valve off.
6. Install Tank Ball Valve
NOTE: Do not tamper with the air valve on low side of storage tank. It
has been preset at 8–10 psi by the manufacturer.
1) Apply Teflon tape on the valve thread on top of the tank.
2) Connect ball valve to the thread. Make sure it is tight but not
overly tight.
3) Connect the yellow tubing to the ball valve by pushing it through
the quick connect inlet of ball valve.
6) Insert black tubing to the quick fitting connector of the saddle
valve.
7) Other end of black tubing should connect to flow restrictor at the
end with black lock pin. The flow restrictor is connected to the
waste outlet of RO TFC membrane. See fig 3 on page 11.