Instructions / Assembly

RO Membrane Cartridge Replacement
1) Disconnect the tubing from connector as shown in the diagram below.
3) Insert the New RO membrane cartridge into the housing as shown
in the diagram below. The O-rings on the product water tube of
the RO membrane cartridge MUST FULLY SIT in the membrane
housing for proper operation. Also, make sure that the Brine Seal
on the membrane seals with no gaps or wrinkles inside the
membrane housing. Once the RO membrane cartridge is installed,
replace the end cap and reconnect the tubing.
Insert the RO membrane cartridge
in this direction
O-ring on the product water tube
Brine Seal
2) Remove the membrane housing end cap by turning cap counter-
clockwise as shown in the diagram below using the supplied blue
wrench. Slide out the used membrane and discard.
Turn counterclockwise
to unscrew the end cap