UNDER COUNTER WATER FILTER SYSTEM User Manual Model# AF-4003
Your box contains: Filter Assembly Feed Water Adapter* Faucet Box Red & blue tubing Wrench User Manual * Feed Water Adapter design can vary depending on availability. Know your filter Stage 3 Stage 2 Stage 1 Specifications ATTRIBUTE VALUE Temperature Range 40°F - 100°F Service Flow 1.
Tools & Materials Required for Installation B A Blue Tubing Out Red Tubing • Drill with 1/2″ Drill Bit (type as required) if faucet needs to be mounted • Adjustable Open-End Wrenches • Phillips and Flat Blade Screwdrivers • Feed water supply valve and adapter Faucet In Installing your filter IMPORTANT - - Install or store where it will not be exposed to temperatures below freezing or exposed to any type of weather. Water freezing in the system will damage it.
Installation 1. Faucet Installation 1) While selecting location for faucet, make sure faucet base sits flat against the surface at the selected location so the gasket will seal, and the faucet stud is accessible from below. 2) Slide Escutcheon chrome plate and large rubber gasket onto stem of faucet and place faucet onto sink with stem going through the hole.
2. Feed-Water Supply Installation CAUTION: The water supply to the unit MUST be from the COLD-WATER LINE. HOT WATER will severely damage the system. 1) Locate the cold water (angle) shut off valve (see picture below) underneath the sink and turn it off. Open the cold-water faucet to release the pressure. On single-handle kitchen faucets, the hot water may have to be turned off to prevent any hot water cross over.
Connection to the Filter Assembly Your filter assembly comes pre-installed with filter cartridges. You only need to attach the quick fitting elbow connectors to inlet and outlet of the filter assembly and attach feed water and faucet tubes to them. Once connected, the system will be ready for use. Remove the color-coded lock pins before inserting the tubes and replace after you are done.
Replacing Filter Cartridge This filter system contains replaceable components called filter cartridges critical to efficiency of the system. Replacement of these cartridges should be with one of identical specifications to assure same efficiency and contaminant reduction performance. STEPS: 1. Shut off the feed water to the system by turning the knob on water supply adapter clockwise until it stops. 2. Press down on faucet handle to relieve pressure. 3. Allow 2-3 minutes for pressure in the system to drop.
Register Your Product Give yourself complete peace of mind and register product online to receive timely reminders for filter replacements & for quick support. Register here: https://www.anchorfilters.com/pr oduct-registration OR Technical Support At Anchor USA, we are always here to help you. With 24-hour access to our company contact web page, you can drop a message or email us directly anytime, and one of our representatives will respond to your query in less than 24-hrs. Web: https://www.