Instructions / Assembly

ManualsBrandsANCHOR WATER FILTERS ManualsCountertop Water Filters7-Stage Counter Top Filtration System with LCD Display in Chrome

1. Installing Batteries

From base of the filter unit, remove

the protective sticker (used to protect

from water) and slide off the battery

cover. Install the 2 AAA batteries

(included) in the battery compartment

and slide back and fix both, cover and

sticker.

We have made it easy for you to install the Anchor Countertop Water

Filter. The shipped unit comes pre-installed with filter cartridge, faucet,

diverter valve, and tube. The only thing you need to do is to install

batteries, connect diverter valve to your faucet, and start enjoying the

clean refreshing water.

Installing Your Filter

This is the

This

the

diverter valve

Steps for installation:

Push & Pull Type

OUTSIDE

INSIDE

- OR -

i. Remove existing aerator from the faucet.

Note the threads in your

faucet. If the threads are on the:

Aerator

2. Connecting Faucet

Summary of content (5 pages)

PAGE 1
Installing Your Filter We have made it easy for you to install the Anchor Countertop Water Filter. The shipped unit comes pre-installed with filter cartridge, faucet, diverter valve, and tube. The only thing you need to do is to install batteries, connect diverter valve to your faucet, and start enjoying the clean refreshing water. This is the diverter valve Push & Pull Type Steps for installation: 1.
PAGE 2
ii. Based on your faucet threads described above, connect the divertor on the faucet as shown in the image below: a. Faucet with outside thread - the diverter valve should screw right on b. Faucet with inside thread - enclosed adapter ring and gasket must be used If your faucet has non-standard threads, try the supplied universal adapter or purchase a special adapter from your local hardware store. After setting up the faucet, do the following: 1.
PAGE 3
2. Turn on the faucet and pull out the stick of the diverter valve as shown in the image. The diverter valve will divert water to the filter unit and water will come out of the spout in the filter. 3. Allow it to run for several minutes to flush out the carbon fines (blackish specs). Initially, the water may contain tiny air bubbles and taste slightly sweet - this is normal and harmless, and will clear up after flushing. 4.
PAGE 4
Replacing the Filter Cartridge 1. Turn off water. Unscrew the housing from base by turning it counterclockwise using the supplied filter wrench. 2. Remove the old cartridge and discard. At this point, it is recommended to clean the housing from inside. Check the O-ring for wear & tear. Oring rests above the thread in the base. - If it is worn, replace it. - If it is in good working condition, lubricate it with food-grade petroleum jelly to ensure it lies flat and prevents leaking. 3. 4.
PAGE 5
Battery Replacement 1. Low Battery Power Alert When the battery power is low, the electronic filter monitor generates an audible sound and a battery symbol blinks on the top right corner of the LCD. When this happens, replace the batteries. After the batteries are replaced, the sound and blinking will stop. 2. Last data Automatically Memorized The Anchor DigiPure 9000s is operated by 2 AAA alkaline batteries. The batteries last more than a year.