Owner's manual

ANCHOR SPAN LINER

GABLE END OF

LINER - ATTACHED

TO FIRST MID.

STEP 1

BE CERTAIN GABLE END VELCRO IS OPEN BEFORE BEGINNING INSTALLATION. CONNECT PULL ROPES TO D-

RINGS AT LOWER ENDS OF LINER MID.

STARTING AT CHANNEL OPENINGS IN BEAMS, SLIDE KEDAR INTO INSIDE CHANNELS OF BEAMS. START BOTH

SIDES OF MID AT THE SAME TIME.

MIDS WILL BE PULLED IN WITH PULL ROPES. PULLEY MAY BE ATTACHED AT TOP ARCH OF FRAME FOR THIS PUR-

POSE, OR PUSH POLES CAN BE USED.

KEDARS

GABLE END VELCRO

MUST BE OPEN

BEFORE PULLING

LINER IN CHANNEL.

FIRST MID WITH GABLE

END ATTACHED.

FIRST MID WITH GABLE

END ATTACHED.

MID

CROSS SECTION LOOKING

AT SIDE OF ANCHORSPAN

GABLE END

ATTACH GABLE END TO

FRAME AT EAVE BAR.

ANCHORSPAN

BEAM (TYP.)

SLIDE KEDAR INTO

BOTH CHANNELS

SIMULTANEOUSLY.

PAGE 1
ANCHOR SPAN LINER KEDARS GABLE END OF LINER - ATTACHED TO FIRST MID. GABLE END VELCRO MUST BE OPEN BEFORE PULLING LINER IN CHANNEL. STEP 1 BE CERTAIN GABLE END VELCRO IS OPEN BEFORE BEGINNING INSTALLATION. CONNECT PULL ROPES TO DRINGS AT LOWER ENDS OF LINER MID. STARTING AT CHANNEL OPENINGS IN BEAMS, SLIDE KEDAR INTO INSIDE CHANNELS OF BEAMS. START BOTH SIDES OF MID AT THE SAME TIME. MIDS WILL BE PULLED IN WITH PULL ROPES.
PAGE 2
GABLE END HAS STRAPS FOR ATTACHING TO END UPRIGHTS. ATTACH STRAPS TO END EAVE BARS (IF WALLS WILL BE INSTALLED, FASTEN STRAPS AFTER INSTALLATION OF WALLS.) STEP 2 PULL LINER MIDS IN EVENLY SO THAT THEY STOP AT THE SAME LEVEL ON EACH SIDE OF THE BUILDING. AT EACH CORNER OF LINER, HOOK SNAP ON STRAP INTO CHANNEL ON EAVE BAR AND THEN TIGHTEN STRAP.