Assembly Instructions Fiesta® Frame Tent 18’ through 22’ Wide Systems With Expandable Kits SALES OFFICES: 1100 BURCH DRIVE PO BOX 3477 EVANSVILLE, IN 47733 USA PHONE: 812-867-2421 FAX: 812-867-0547 1-800-544-4445 EMAIL: tents@anchorinc.com www.anchorinc.
BASE UNIT 18’ x 18’ Through 22’ x 22’ INSPECT SITE CAUTION: LAYOUT AND CHECK Consult your local utility locator service or the National Utility Locating Contractors Association (NULCA) prior to installation. Prior to actual tent assembly, be sure to look up, down, above & below for obstacles, pipes, wires, trouble, etc. Utilize parts list for a quick I.D. and a check list to ensure that you have all parts.
PARTS LIST * (2) RAFTERS HAVE PTEB-3 ATTACHED STAKING TABLE - 10’ STARTER KIT Part Description Quantity 1” x 30” Single Head Stake (3704201) 4* 1” Web Guy with Ratchet (22010) 4 Note: See page 9 for staking layout sample. * IMPORTANT NOTE: REFER TO CAUTION STATEMENT #2 FOR IMPORTANT WARNING ABOUT NUMBER OF STAKES SUPPLIED.
* For 10’-0” Starter and Extension parts and instructions, see pages 6 and 7.
Warning: Do not drag fabric tent top across hard or rough surfaces as abrasion from tent hardware is possible.
4’-0” 4’-0” (2) 10” nails in each base plate. Hammer down flush with base plate to secure.
3a RIDGE AND CROSS BARS Connect 2-piece ridge and pin to PTTs using the PTRE pointed downward so that the ridge is elevated. Connect 2-pc ridge and pin to PTTs using the PTRE Pin Cross bars to PTEBssoon rafters. pointed downward that the ridge is elevated. PTEB Pin cross bars together and attach to frame as shown.
STAKING TABLE - 10’ EXTENSION KIT Part Description Quantity 1” x 30” Single Head Stake (3704201) 2 1” Web Guy with Ratchet (22010) 2 Note: See page 9 for staking layout sample. 3a RIDGE AND CROSS BARS Slide PTR onto 10’-0” ridge. Align with hole at center and pin. Repeat for each 10’-0” ridge. Pin 10’0” ridges together and add existing ridges to each end. Lift and pin assembled ridges to PTTs. Insert PTR-PTI rafters into PTRs and PTIs and pin. Attach cross bars to frame as shown.
WEB GUY WITH 1” x 30” STAKE (TYP. 6) ** WEB GUY LAYOUT FOR 20’ x 40’ ** To find diagonal measurement: diagonal = width² + length² * IMPORTANT NOTE: REFER TO CAUTION STATEMENT #2 FOR IMPORTANT WARNING ABOUT NUMBER OF STAKES SUPPLIED. (SEE BACK PAGE OF THIS MANUAL) THE INSTALLER MUST USE THE LOCAL SOIL CONDITIONS TO CALCULATE THE ACTUAL NUMBER OF STAKES REQUIRED AND IS RESPONSIBLE FOR THE STAKING PATTERN AND CONFIGURATION.
EVANSVILLE, INDIANA PHONE NUMBER 812· 867· 2421 FAX NUMBER 812· 867· 0547 Anchor products are of superior design and operate best within the parameters of these instructions. It is imperative that the instructions be carefully read and COMPLETELY FOLLOWED. Please read installation instructions before the installation or removal of this product. Installation instructions are available online at www.anchorinc.com or by calling 1-800-544-4445. CAUTION: 1.