Owner`s manual

GENERAL OPERATION
8
MegaVox Pro Control Panel
1. Set all input level controls to minimum before turning on the
power.
2. Plug a microphone into a Mic jack, or an audio source into
the Line-in jack.
3. Turn POWER on, the red LED near the switch will light. If
the LED flashes or dose not light, charge the battery.
4. Slowly increase the level control adjacent to the input jack
used to desired volume.
NOTE:
Instructions
for wireless
operation can
be found on
page 10.
Charging Indicator
Line In
Controller
Mic/Signal Alert
Controller
Wireless
Receiver 2
Controller
Wireless
Receiver 1
Controller
Line Out Jack
Charger Input
Line In Jack
Speaker Out
Jack
Mic In Jack
Wireless
Receiver 1
Wireless
Receiver 2
Power SwitchPower/Battery Indicator Signal Alert Button
NOTE:
All in/out line
connections
must be made
with shielded
cable to avoid
hum, buzzing,
or radio
interference.
MEGA-6000U2
Back Panel
MEGA-6000U1
Back Panel
Wireless Receiver/
Mic Controller
Mic Controller
MEGA-6000
Back Panel