Instructions / Assembly

11
Installation (Continued):
Figure 8
8. Connect the range hood to a designated standard outlet (120-Volt,
60Hz, AC only) or cut off the plug and connect three wires (black,
white and green) to house wires and cap with wire connectors. Con-
nect according to colors (i.e. black to black, white to white, and
green to green) as shown in Figure 6.
9. Store excess wires in the wiring box.
Figure 8
10. Install both chimneys and tighten screws to secure the lower chim-
ney to the range hood as shown in Figure 8.
11. To avoid scratching the chimney, extend the upper chimney slowly
and carefully to the chimney-mounting bracket and tigten screws
as shown in Figure 9.
12. To install baffle filters, refer to Figure 10 for the following three
steps:
Angle baffle filter toward back of hood.
Slide the knob toward the metal filter handle and push up.
Release the knob until it fits into resting positions.
13. Repeat Step 12 to install all baffle filters.
14. Turn powe ON in control panel. Check all lights and fan operations.
15. Make sure to leave this Installation Guide for the homeowner.
Figure 9
Figure 10