Installation Guide

— 22 —
STEP 10B (cabinet hoods only)
Venting
• Depending on exterior ventilation chosen (see page 17), either exit the ducting through the ceiling or wall.
• Always use rigid type metal/aluminum duct tube (follow the building codes in your area) to
maximizeairow.Makesurethatthebackdraftapscanopen,toallowmaximumairow.
Connect the duct tube to the vent/damper and securely seal with certied aluminum or foil tape
so that it is air tight. Please check the building codes in your city to learn which tape product is
recommended.
• For external recirculation, purchase kit at www.anconahome.com (sold separately), and move
locker (located next to motor) into position. (see Figure #12)
IMPORTANT:
• Observeallgoverningcodesandordinances.
• It is the customer’s responsibility to contact a qualified electrical installer.
• Ifcodespermitandaseparategroundwireisused,itisrecommendedthata
qualified electrician determine that the ground path is adequate. A 120-Volt, 60
Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-ampcircuit,
fused on both sides of the line.
• DONOTgroundtoagaspipe.
• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.
• DONOThaveafuseintheneutralorgroundcircuit.
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric
shock by providing an escape wire for the electric current.
WARNING: Improper grounding can result in a risk of electric shock.
• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
• Therangehoodmustbeconnectedwithcopperwire/plugonly.Therangehoodshouldbeconnecteddirectlyto
the fused disconnect (or circuit breaker) box through flexible armored or non-metallic sheathed copper cable. UL/
CSA listed strain relief must be provided at each end of the power supply cable. Use only with range hood cord-
connection kits that have been investigated and found acceptable for use with this model.
Installation
STEP 14A / STEP 11B (all models)
Install Filters
To install lters for the following four steps (See Figure #13):
• Angle the lter into slots at the back of the hood.
• Push the button on handle of the lter.
• Release the handle once the lter ts into a resting position.
• Repeat to install all lters.
Fig. #13
Fig. #12