Installation Guide

Installations (refer to Page 4 for parts):
NOTE: Use threaded drywall anchors only when
mounting the hood on sheet rock. Mounting
the hood on wall studs or lumbars is highly
recommended.
Step 1: Measuring
• Measure the distance between stove top and the bottom of range hood. A distance of 24” to 30” is
recommended with a minimum of 30” for gas stove tops.
• To reach 9ft ceiling make sure hood is installed at 31” from cooking surface
• If you require longer chimney flue to reach your ceiling please contact vendor.
Step 2: Installing the hood mounting bracket
• The range hood will be installed on top of this bracket (requires screw A & B) (See Figure # 1)
• Using references in Height & Clearance on Page 5 and Measurements and Diagrams on Page 16,
Drill 3 holes that will be used to fix the lower mounting bracket.
Step 3: Installing the upper chimney bracket
• Drill 2 holes according to the size of the upper mounting bracket. The upper mounting bracket
should be positioned flush with the top of the outside chimney (See Figure 1)
• Screw upper and hood mounting brackets in tightly.
INSTALLATION:
For consumer safety reasons, mounting screws and anchors have not been supplied with this range
hood. Different wall and cabinetry construction methods require specific types of screws and wall
anchors. Please consult your installation specialist regarding the best type of mounting screws and
wall anchors to suit your homes construction.