Installation Guide

Step 8: Installing baffle filters

• To install filters for the following four steps (See Figure # 8):

- Angle the filter into slots at the back of the hood.

- Push the button on handle of the filter.

- Release the handle once the filter fits into a resting position.

- Repeat to install all filters.

Step 9

: Test hood

• Turn power On in control panel.

• Check all lights and fan operations.

• Make sure to leave this Installation Manual for the homeowner.

INSTALLATION CONTINUE:

Step 7: Installing the decorative chimney and inner chimney bracket

• Remove the protective coating from the inner chimney. Carefully slide the inner chimney down into the

outer chimney.

• Use 2 screws (requires screw F) to fix the two chimneys together with the lower chimney bracket,

make sure inside chimney is moving freely. (See Figure # 6)

• Install the chimneys on the hood. Pull out the inner chimney and adjust height according to the position

of the inner chimney bracket on the wall.

• Fix the inner chimney on the bracket with two screws (requires screw F) (See Figure # 7)