Full Product Manual
— 16 —
Be sure electrical power is off and all surfaces are cool
before cleaning or servicing any part of the hood.
Range Hood Body
• Do not use a steel wool pad; it will scratch the surface.
• To clean the stainless steel surface, use warm soapy
water or a stainless steel cleaner. Closely follow the
cleanser label instructions. DO NOT use corrosive or
abrasive detergents, ammonia products, abrasives or
oven cleaners. Always wipe the surface in the direction
of the grain.
Bafe Filters and Grease Trays
• The saturation of greasy residue in the fan and lters
may cause increased inammability. Keep unit clean
and free of grease and residue build-up at all times to
prevent possible res.
• Bafe lters and grease trays can be cleaned in a
standard dishwasher or by using a mild cleaner. DO
NOT use corrosive or abrasive detergents, ammonia
products, or oven cleaners.
• To remove, rst drain and wipe all excess grease with
a dry paper towel. Grasp the bafe lter knobs and pull
them up, forward and out. Grasp the grease trays and
carefully lift them up and out of the hood track.
Maintenance
Replacing the Light Bulbs Cleaning the Range Hood
• When cleaning is completed, replace the grease trays
and bafe lters as shown in Step 13 and Step 14.
u
Unplug the unit from the AC outlet.
v
Remove ve screws from the light panel, then remove
the light bulbs by popping them out.
w Disconnect the light clip.
x
Reverse the removal procedures to install the new
light bulbs and plug the unit back in.