Use and Care Guide

— 12 —

Installation

STEP 6

Preparations

NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.

• Determine and mark the centre line on the ceiling or wall where the range hood will be installed.

• Make sure there is proper clearance within the ceiling or wall for exhaust vent.

•

Duetotheweightandsizeofthisunit,pleasemakesurethatthesupportsystemorframeworkbeingusedisstableand

secure in the ceiling or wall.

• Put a thick, protective covering over counter top, cook top or range to protect from damage or dirt.

• Removeanyhazardousobjectsaroundtheareawheninstalling.

CAUTION

If moving the cooking range is necessary to install the hood, turn OFF the power on an electric range at the main

electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

STEP 7

Create Exterior Ventilation (New Installation Only)

• Choose one of the exterior venting methods shown on Page 11.

• Create the exterior ventilation hole.

• Following recommendations and calculations specied on Pages 10 to 11, use new aluminum/metal ducting cut

specically for the distance between the range hood damper and the exterior damper.

• Fasten all connections with sheet metal screws and tape all joints with certied aluminum or foil tape.

• Please check the building codes in your city to learn which tape product is recommended.

STEP 8

Install Ductwork

• Use the tool to punch the wiring hole, from the two options for holes. Please choose hole A or hole B accordingly to

wiring requirement. (Fig # 1)

• Loosen two screws of electronic box, connect cable to range hood wiring using included wire connectors. Connect

BLACK to BLACK, WHITE to WHITE and GREEN or BARE WIRE to GREEN ground screw. DO NOT FORGET TO

CONNECT THE GROUND. (Fig # 2)

Fig #1 Fig #2