Installation Guide

NEW INSTALLATION:

SAFETY WARNING: Risk of electrical shock. This range hood must be properly grounded. Make sure

this is done by a qualified electrician in accordance with all applicable national and local electrical codes.

Before connecting wires, switch power off at service panel and lock service panel to prevent power from

being switched on accidentally.

Step 6: Venting

certified aluminum or foil tape so that it is air tight. Please check the

building codes in your city to learn which tape product is recommended.

Step 7: Electrical Connection

DON’T FORGET TO CONNECT THE GROUND!

Step 8: Installing Filters

Step 5: Installing the Hood

• Open the wiring compartment and secure the leads inside.

• WARNING: ALL CONNECTORS MUST BE ENCLOSED

IN THE WIRING COMPARTMENT.

Fig #6

• Using measurements provided on Page 15, measure and drill

4 holes into bottom of cabinet. (See Fig #6)

• Depending on exterior venting chosen (See page 7), use

measurements provided on Page 15 and cut vent hold in cabinet.

• Align range hood to the holes in the bottom of the cabinet and

screw in using the supplied screws. (See Fig #6)

Fig #7

hood

• To install filters: (See Fig#8)