Use and Care Manual

 The baffle filters channel grease released by cooking foods, prevententing flamming foods on
the cook top from damaging the inside of the range hood. For this reason, the baffle filters
must be installed during range hood use.
 The baffle filters should be cleaned once a month, or as needed.
INSTALLATION:
12
Step 8: Reinstall Baffle Filter
1
Insert one end of the filter into
the upper channel of the power
pack.
2
Raise the other end towards the
inside of power pack and insert
in the grease drip rail of the
power pack.
NOTE: Assemble the metal handles to the filters, using provided no. 8-32 x 1/4" screws, before installing
them in the power pack. It is recommended to install side filters first and finish with center one(s).
CAUTION: Remove plastic film covering filters before installing them.
Replacing the light bulb:
1 Remove baffle filter as per installation.
2
Make sure the hood is disconnected or close the
circuit breaker. Reach into the range hood and
disconnect power clip.
3 Reach into interior of range hood until touching
both lateral clips located on the side of the puck
light. Gently squeeze and push down until puck
pops out from its location.
4
To reinstall new puck light, follow instruction 3
in reverse order.