Use and Care Manual

The electrode of the electronic ignition system is positioned above the surface of the burner base. Do
not remove a burner cap or touch the electrode of a burner while another is turned on. Damage or
electrical shock may occur.
1. Place burner heads over the burner base. Make sure the hole in the burner head is properly
aligned with the electrode in the burner base (see Figure 16).
2. Place the burner caps on the burner heads. Make sure that the burner caps are properly seated
on the burner head (see Figure 17).
3. Operation of the electric igniters should be tested after the cooktop and supply line have been
carefully checked for leaks and the cooktop has been connected to the electrical power. To check
igniters, push and turn a burner valve to the LITE position. All spark igniters will make a series of
sparks (ticking sounds), but only the burner turned to LITE will light.
Figure 16
Figure 17
26