Installation Guide

— 38 —
Before Calling for Service
OVEN TEMPERATURE TOO HIGH OR
TOO LOW
Wastheovenpreheated?
Push in and rotate the Temperature knob to the desired
setting and let the oven preheat until it reaches the
temperature before you begin cooking.
Aretherackspositionedproperly?
See pages 31 to 32 for rack positioning.
Isthereproperaircirculationaroundbakeware?
If bakeware takes up too much room, air circulation will
be reduced.
Isthebatterevenlydistributedinthepan?
Check that batter is level in the pan when baking.
Istheproperlengthoftimebeingused?
Make sure proper cooking time was used.
Hastheovendoorbeenopenedwhilecooking?
Oven“peeking”releasesovenheatandcanresultin
longer cooking times.
Arebakeditemstoobrownonthebottom?
Move rack to higher position in the oven.
Arepiecrustedgesbrowningearly?
Usealuminumfoiltocovertheedgeofthecrustand/or
reduce baking temperature.
NO SPARK WHEN LIGHTING BURNER
Electricalsupply-Theelectricalwiresortheplug
are not connected properly.
Connect with electrical power again. If the problem
continues, contact a qualied technician.
Burner-Theburnerisnotinstalledcorrectly.
Installtheburneragain.See“BurnerRingsandCaps
Replacement” section.
Sparkpin-Ignitionelectrodeandtheholearenot
inserted properly.
Installtheburneragain.See“BurnerRingsandCaps
Replacement” section.
THE FLAME GOES OUT ONCE
RELEASING THE KNOB
Safetyvalve-Knobnotpresseddownlongenough.
Press and turn the knob again and hold down three
to ve seconds after the burner has been lit. This is a
safety feature.
BURNER WON’T IGNITE OR BURNS
UNEVENLY
Gasvalve-Thevalveisnotopen.
Make sure the valve is completely open.
Gaspipe-Theremaybeairinthegaspipe.
Igniterepeatedlyuntilamecatchestoreleasetheair
from the pipe.
Burnercapissues.
The burner cap is not placed correctly; replace the
burner cap. Some holes in the lid are blocked; clean the
holes of the lid.
Sparkpin-Thesparkpiniswetorcontaminatedby
the food.
Clean and dry the spark pin.
Gasconnectingpipes-Thegasconnectingpipes
are blocked or pinched.
Contact a qualied technician. Adjust or change the
connecting pipes.
STRANGE SMELL
Gasleak-Turnoffthegasandcontacta
qualied technician.
Thegassupplypipeisoldand/orbroken.Change
the gas supply pipe.