Instructions / Assembly

— 38 —
Before Calling for Service
OVEN TEMPERATURE TOO HIGH OR
TOO LOW
• Wastheovenpreheated?
Push in and rotate the Temperature knob to the desired
setting and let the oven preheat until it reaches the
temperature before you begin cooking.
• Aretherackspositionedproperly?
See pages 31 to 32 for rack positioning.
• Isthereproperaircirculationaroundbakeware?
If bakeware takes up too much room, air circulation will
be reduced.
• Isthebatterevenlydistributedinthepan?
Check that batter is level in the pan when baking.
• Istheproperlengthoftimebeingused?
Make sure proper cooking time was used.
• Hastheovendoorbeenopenedwhilecooking?
Oven“peeking”releasesovenheatandcanresultin
longer cooking times.
• Arebakeditemstoobrownonthebottom?
Move rack to higher position in the oven.
• Arepiecrustedgesbrowningearly?
Usealuminumfoiltocovertheedgeofthecrustand/or
reduce baking temperature.
NO SPARK WHEN LIGHTING BURNER
• Electricalsupply-Theelectricalwiresortheplug
are not connected properly.
Connect with electrical power again. If the problem
continues, contact a qualied technician.
• Burner-Theburnerisnotinstalledcorrectly.
Installtheburneragain.See“BurnerRingsandCaps
Replacement” section.
• Sparkpin-Ignitionelectrodeandtheholearenot
inserted properly.
Installtheburneragain.See“BurnerRingsandCaps
Replacement” section.
THE FLAME GOES OUT ONCE
RELEASING THE KNOB
• Safetyvalve-Knobnotpresseddownlongenough.
Press and turn the knob again and hold down three
to ve seconds after the burner has been lit. This is a
safety feature.
BURNER WON’T IGNITE OR BURNS
UNEVENLY
• Gasvalve-Thevalveisnotopen.
Make sure the valve is completely open.
• Gaspipe-Theremaybeairinthegaspipe.
Igniterepeatedlyuntilamecatchestoreleasetheair
from the pipe.
• Burnercapissues.
The burner cap is not placed correctly; replace the
burner cap. Some holes in the lid are blocked; clean the
holes of the lid.
• Sparkpin-Thesparkpiniswetorcontaminatedby
the food.
Clean and dry the spark pin.
• Gasconnectingpipes-Thegasconnectingpipes
are blocked or pinched.
Contact a qualied technician. Adjust or change the
connecting pipes.
STRANGE SMELL
• Gasleak-Turnoffthegasandcontacta
qualied technician.
• Thegassupplypipeisoldand/orbroken.Change
the gas supply pipe.