OWNER’S MANUAL Capri Series Luxury Sinks
INSTALLATION INSTRUCTIONS General Recommendations: Read installation and maintenance instructions, thoroughly before installation. Be sure to use proper tools and always wear personal safety accessories for your protection. Long-Life Care Ancona Stainless Steel Sinks are easy to keep looking new, longer with minimal care. For best results, always rinse with a mild soap and wipe after each use. Rub lightly with soft cloth in the direction of the grain line on a regular basis.
TOPMOUNT INSTALLATION Please carefully read complete instructions before beginning installation. Note: These instructions are for installation with solid surface, composite material countertops. Ancona recommends professional countertop installers, customer is responsible for damage to the countertop or sink during installation. 1. Unpack the new sink and check the contents of the materials supplied: Sink, Mounting brackets, and cut-out template (depending on model). 2. Preparing the countertop: A.
TOPMOUNT INSTALLATION 5. Attaching the mounting clips Attach the topmount clips (AA) to the sink (A). 6. Installing the sink A. Apply silicone sealant (not included) around the underside and lip of the sink (A). B. Carefully lower the sink (A) into The Counter. C. Tighten the screws on the topmount clips (AA) evenly until the sink (A) is flush with the counter. Do not over-tighten. D. Wipe excess sealant with a rag. 7. Connect drain and water supply according to manufactures instruction.
UNDERMOUNT INSTALLATION Please carefully read complete instructions before beginning installation. Note: These instructions are for installation with solid surface, composite material countertops. Ancona recommends professional countertop installers, customer is responsible for damage to the countertop or sink during installation. 1 .Unpack the new sink and check the contents of the materials supplied: Sink, Mounting brackets, and cut-out template (depending on model). 2.
UNDERMOUNT INSTALLATION 6. Loosely attach mounting brackets to the countertop, parallel to the cut-out opening using the supplied mounting screws and nuts. Mounting screws with brass inserts are supplied with the sink, however, countertop material vary and the correct type of fasteners should be recommended by your installer or supplier. 7. Clean sink flange and underside of cut-out area of countertop, making sure that the area is smooth and free of grease.
CARE AND MAINTENANCE ALWAYS: - Clean everyday by thoroughly rinsing with a mild soap and warm water and wipe dry. - Rub lightly with a soft cloth in the direction of grain lines on a regular basis for additional preventive cleaning. - Keep the sink free of any standing water as this can cause a buildup of mineral deposit, which can affect the appearance of your sink. - Any stubborn stains should be removed by scrubbing in the direction of the grain with a mild abrasive such as Comet.
ANCONA LIMITED LIFETIME WARRANTY This Ancona Sink product (the “Product”) is warranted by AMS, in the manner fully set forth below, to be free from defects in material and workmanship and to operate properly in accordance with specifications, provided that it is used under the normal operating conditions and for ordinary homfe use and service in Canada and the USA. AMS provides a limited lifetime warranty on manufacturing defects in material and workmanship for its Products.