Warranty

ManualsBrandsAncona ManualsBathEleganzia 2-Handle Deck-Mount Roman Tub Faucet with Handshower in Chrome Finish

P S I

G P M

Two Handle Roman Tub Bathroom Faucet

STANDARDS

Tools:

PLUMBERS PUTTY FLASHLIGHT BASIN WRENCH

SAFETY GLASSES SCREWDRIVER

PLIERSCHANNELLOCKS ADJUSTABLE WRENCH

HEX-KEY TAPE

Attention:

Helpful Information

Flow Rate Chart

Important

Eleganzia

2017-12-22 MAAN4322-1

SEALED-TUBE

Please keep the tools for future use!

ASME A112.18.1/CSA B125.1

ASME A112.18.2/CSA B125.2

LISTED IAPMO/cUPC

Gather the necessary tools as shown below to complete the installation of

this faucet. Some may not be needed depending on the model of faucet you

are installing. Check with your local hardware store on the requirements of

your installation situation.

WARNING:

For easy installation, you will need:

- To read all the installation instructions completely before beginning.

- To read all the warning, attention and maintenance information.

- To purchase the proper supply lines.

Tighten connection with two wrench to prevent

damage to tube body. Be careful not to bend the

stem as this will void the product warranty.

Summary of content (4 pages)

PAGE 1
Helpful Information Tools: Gather the necessary tools as shown below to complete the installation of this faucet. Some may not be needed depending on the model of faucet you are installing. Check with your local hardware store on the requirements of your installation situation. Eleganzia © Two Handle Roman Tub Bathroom Faucet ® PLUMBERS PUTTY STANDARDS ASME A112.18.1/CSA B125.1 ASME A112.18.2/CSA B125.
PAGE 2
Installation size map 3 9/16 in. (89.8 mm) 4 1/2 in. (115 mm) 1 1/2 in. (38.1 mm) 2 13/16 in. (71.9 mm) 2 3/8 in. (60 mm) 2 3/16 in. (55 mm) 8 7/16 in. (213.9 mm) 4 5/8 in. (117.3 mm) Faucet Installation 10 - 12 in. (254 - 304 mm) 6 7/8 in. (175.2 mm) 5 11/16 in. (145.2 mm) 8 in. (203.6 mm) 5 - 6 in. (127 - 152.4 mm) 1 Disassemble the parts as shown. 3 1/16 in. (77.4 mm) 1 3/8 in.
PAGE 3
Maintenance 4 If faucet leaks from the handle or drips from spout, please replace cartridge following the steps: Connect the parts with supply lines as shown and tighten them with wrench. 1 Cold water Hot water A. Remove the handle counter clockwise, as shown. B. C. Connect to water supply lines with either 1 risers with the coupling nuts or 5 supplied tube head interior connector or 2 Unscrew the old cartridge② with Adjustable Wrench①, then take it out.
PAGE 4
Cleaning and care Daily cleaning and care are required in order to keep the product shining and working properly. 1. 2. 3. 4. Clean it with water and dry it with soft cloth. Clean the product with gentle liquid or glass cleaner. Don't use acid cleaner. Don't clean with abrasive material, abrasive paper or knife. NO.