Installation Guide

Installation cont’d
Step 3: Marking holes for wall mount posts (fig. 3)
- Take towel warmer with 4 wall leg mounted, as per step 2
- Position against the wall where you will want to install the towel warmer
- Ensure the hard wire post is turned in at 90 degrees so you can also mark this leg
- Use light pencil to mark legs on the wall (you may want to erase the pencil mark following
installation completion, so make sure you mark lightly)
Step 4: Installing wall posts (fig. 4)
- If installing on dry wall with no rear beam support:
o Drill a hole in the center of each of the 4 circles marked on the wall as per step 3
o Ensure drilled hole is large enough to insert the plastic plug provided – part a)
o Insert/ screw the plastic plug in each of the 4 holes
o Position wall post b) on top of plastic plug and put in screw c) to set in place
- If installing on surface with rear support, e.g. wood studs
o Pre-drill small hole in the center of each circle as per step 3
o Position wall post b) on top of pre-drilled hole and put in screw c) to set in place
Step 5: Installing hard wire leg (fig. 5)
- Create a hole in the wall to let the hard wire leg go through
- The leg will be covered by plate h) so the hole should be large enough to allow space for
electrical connection and leg to go through but not too large so the plate can covered it fully
- Electrical wiring must be done by qualified professionals and in accordance with all applicable
codes and standards, including fire-rated constructions
Step 6: Mounting main body onto wall (fig. 6)
- Take main body and position each of the 4 legs on top of the wall post b)
- Once inserted use Allen Key to tighten each set screw g)
- The installation should be complete
Step 7: Power the Towel Warmer
- Remove protective white covers, they are located at the end of each vertical bars
- Turn the switch on to start towel warmer; the on-off switch is located at the end of one of the
posts
- The towel warmer should reach its pre-set temperature in approximately 15 minutes
- This towel warmer is designed to operate continuously and can be left on all the times. To save
electricity it can be turned off when not in use.
Fig. 4 Fig. 6 Fig. 3 Fig.5
h
Model : Ancona Comfort 7