Comfort 5 Floor Curved Towel Warmer Installation and Operations Manual 03/14/2016 MAAN5633-01
REQUIRED TOOLS ALLEN KEY ELECTRICAL REQUIREMENTS: 120V, 80W, 50/60Hz, 0.67A, IP44. MUST HAVE A GROUND CONNECTION. READ ALL INSTRUCTIONS IN THE MANUAL BEFORE INSTALLING THIS TOWEL WARMER. Fig . 1 PARTS FOR INSTALLATION 2X M8x28 2X PRODUCT DIMENSIONS 5-1/4” (133 mm) 4-1/8” (104 mm) 34-1/4” (875.5 mm) 37-1/4” (947.
1. Approved for domestic use only. Do not use outdoors. 2. Install in accordance with n onal and local codes 24” 3. Do not install in the shower, sauna or any wet locations 4. Make sure towel warmer is properly secured to the wall before use. FLOOR PLUG-IN INSTALLATION Step 1: Verifying installation parts (Fig. 1) - Ensure all parts for mounting installation were supplied with your towel warmer. If any are missing, please contact us. Step 2: Installing floor stand posts (Fig.
CAUTION - Overlapping towels may increase towel warmer temperatures. PROPERLY HANG TOWELS. DO NOT OVERLAP TOWELS. Operation and Maintenance Instructions • After installation, connect the electric power and turn on the switch. The indicator light will show red and the towel warmer will start to work. • Turn off the switch when the towel warmer is not in use. The indicator light will turn dark and the towel warmer will stop working. • Clean the towel warmer with a soft dry towel.
Comfort 5 Floor Curved Guide d’installation et de fonctionnement 03/14/2016 MAAN5633-01
CLEF HEXAGONALE Éxigences électriques: 120V, 80W, 60Hz, 0.67A, IP44. Branchez l’unité dans une prise adéquatement reliée à la terre. Lire toutes les instructions dans la section Installation de ce manuel AVANT d’installer le chauffe-serviettes. PIÈCES POUR INSTALLATION Fig . 1 2X M8x28 2X 23-3/4” (604 mm) 19-5/8” (500 mm) 5-1/4” (133 mm) 4-1/8” (104 mm) 34-1/4” (875.5 mm) 37-1/4” (947.
1. Approuvé pour utilisation domestique seulement. Ne pas utiliser à l’extérieur. 2. Installer conformément les codes nationaux et locaux 3. Ne pas installer dans une douche, un sauna ou tout emplacement mouillé 4. Assurez-vous que le chauffe-serviette est adéquatement fixé au mur avant l’utilisation INSTALLATION ÉLECTRIQUE PLANCHER Étape 1: Vérification des pièces d'installation (Fig. 1) - S'assurer que toutes les pièces de montage pour l'installation ont étéfournis avec votre chauffe-serviettes.
Avertissement – Chevaucher les serviettes peut causer une température élevée du chauffe-serviettes. Suspendez les serviettes correctement. Ne pas les faire se chevauche. Instructions de fonctionnement et d’entretien • Après avoir terminé l’installation, brancher le fil électrique et mettre l’interrupteur à «ON». L’indicateur s’allumera en rouge et le chauffe-serviette se mettra en marche. • Mettre l’interrupteur à «OFF» lorsque l’appareil n’est pas utilisé.