User Manual

Knob Symbols
Lighting the Burners
1) To obtain a flame more easily, light the burner before placing a cooking utensil on the burner
grate.
2) To light a burner, press the knob of the burner fully down and turn it anti-clockwise to the
“maximum flow” setting symbol: .
3) After lighting the flame, keep the knob pressed down for about 10 seconds. This is necessary to
heat up the thermocouple and activate the safety valve, which would otherwise cut off the gas
flow.
4) Then check that the flame is even and turn the control knob to adjust the flame as required: .
5) In the instance of a power outage, place a lit match near the burner and proceed as already
described. If the burner does not light after a few attempts, check that the “burner cap” and “flame
cap” are correctly positioned.
ALWAYS USE CAUTION WHEN LIGHTING BURNERS MANUALLY.
6) To turn off the flame, turn the control knob clockwise to the: ● symbol. Before removing pans from
the burners, always lower or turn off the flame.
•
Off - No gas flow
On –Maximum gas flow
Minimum gas flow
14