Comfort 6 Dual Towel Warmer User Manual & Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Carefully read the important information regarding installation, safety and maintenance. Keep these instructions for future reference.
Required Tools STARHEAD SCREWDRIVERS FLAT HEAD SCREWDRIVERS DRILL & BIT MEASURING TAPE 5/16” Diameter LEVEL PENCIL Electrical requirements: 120V, 80W, 60Hz, 0.67A. MUST HAVE A GROUND CONNECTION. Should be protected by a 15 amp GFI circuit breaker or equal. READ ALL INSTRUCTIONS IN THE MANUAL BEFORE INSTALLING THIS TOWEL WARMER. Before You Begin Unpack the towel warmer carefully to avoid any damage or loss of any part.
Product Dimensions 80 cm (31.5 in.) 79 cm (31.1 in.) 11.2 cm (4.4 in.) 6.6 cm 12 cm (2.6 in.) (4.7 in.) 50 cm 46.8 cm (19.6 in.) (18.4 in.) 19.8 cm (7.8 in.) 45 cm (17.7 in.
Plug-In Installation w x • Mount unit on support and tighten all the set screws (e) to the mounting tube (a) with Allen key.
Hardwire Installation w x d h i • Cut cable and leave its length at 25 cm (9.8 in.). • Insert cable through tube (d) and plate (h). • Insert screws (i) to plate (h). • Connect unit. All electrical connections in the junction box must be performed by a fully qualified electrician. y U e • Mount unit on support and tighten all the set screws (e) to the mounting tube (a) with Allen key. • Fasten screws (i) to plate (h).
Operation and Maintenance Instructions • • • • After installation, connect the electric power and turn on the switch. The indicator light will show red and the towel warmer will start to work. Turn off the switch when the towel warmer is not in use. The indicator light will turn dark and the towel warmer will stop working. When cold, clean the towel warmer with a soft dry towel. Do not clean with abrasive cleaning powder. Unplug the unit if not in use for a long period of time.
Please register your product warranty by visiting the Ancona Home website. Canada & USA Phone: 1-800-350-4562 Fax: 800-350-8563 Email: service@anconahome.com Website: www.anconahome.
Timer # PATIM-01 service@anconahome.com • 1-800-350-4562 In-Wall 7 Day Digital Timer Instruction Sheet 1. Remove wall plate and disconnect existing light switch, install junction box with a qualified electrician. 2. Make sure both “hot” (black or red) and neutral (white) wires are present in the junction box. If both wires are not present, additional wiring will be necessary before installation can be completed. 3. Connect red timer wire to wire from towel warmer fixture, using wire connector. (1) 4.
IMPORTANT - Federal Communications Commission Interference Statement This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
