User Manual

ManualsBrandsAnderic ManualsAccessories & SuppliesUniversal IR Compatible with Roku Express Roku SE Remote with Volume Roku/TV Streaming 2-in-1 Remote Control with Learning - Works for Roku + TV (1-Pack)

Anderic

RRST01.2 Advanced Universal

Operating Guide

Thank you for purchasing the Anderic RRST01.2 universal remote control. This remote is

programmed to work with Roku

Media Players and LG

/Vizio

TVs (for the keys: ‘Power,’ ‘Mute,’

‘Vol+/-’). This remote can be programmed to work any TV via the learning method. Please refer to

the “Learning Instructions” section for instructions, no codes needed. However, if you have a

Roku TV, you can program this remote work via the below table “Programming Codes for Roku

TVs.”

NOTE: This remote does not work for Roku Sticks

Downloadable (PDF) version of this manual is available at:

ANDERIC.COM/RRST01

Installing batteries and the wrist strap

Please see the diagram below.

1. Remove the battery cover.

2. Insert the batteries, as shown in the diagram below, matching polarities.

3. Loop the wrist strap around the screw hole and hold in place while

replacing the battery cover.

Summary of content (4 pages)

PAGE 1
Anderic® RRST01.2 Advanced Universal Operating Guide Thank you for purchasing the Anderic RRST01.2 universal remote control. This remote is programmed to work with Roku® Media Players and LG®/Vizio® TVs (for the keys: ‘Power,’ ‘Mute,’ ‘Vol+/-’). This remote can be programmed to work any TV via the learning method. Please refer to the “Learning Instructions” section for instructions, no codes needed.
PAGE 2
Programming Codes for Roku TVs Use the codes below to program to Roku TVs (TVs manufactured by one of the brands below with built-in Roku software). Steps: 1. Take note of the two keys to press from the “Code” column corresponding with your TV brand from the “Brand” column. 2. Press & hold the two keys for about 5 seconds until the indicator light flashes three times. It is now programmed. Note: If the first code you use does not work, try the other brands as well, one of them will most likely work.
PAGE 3
Learning Instructions Note: All keys on the RRST01.2 may are learnable. Original remote is needed. This method does not require codes. 1. Press and hold the & keys simultaneously for about 5 seconds; indicator light will illuminate brighter and remain bright. Release the keys. 2. Point the original remote control head-to-head with the RRST01.2, aligning top edges at about 1-2 inches apart (both remotes should be pointing at each other). 3. On the RRST01.
PAGE 4
original remote until the RRST01.2 indicator light flashes three times and then remains on. Press & keys to save and exit. The key is now programmed to the RRST01.2 and should operate your unit. Still having trouble, please visit Anderic.com/RRST01 for a step-by-step video. Delete all learned keys 1. Press and hold & keys simultaneously for 3 seconds; the indicator light will flash three times to confirm. The deletion of all learned keys is now complete. Reset to factory default status 1.