Installation Guide

6
INSTALL RAIN CAP,
EXTENDER, SCREW
COVERS, & WINDOW
RETAINERS
(Left Hand)
5
a
Tools needed:
1/8”
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
1”
x 3
#8
#10
#12
#6
3/4” Machine Pan Painted
1/2” SMS Pan
1/2” SMS Pan Painted
1/2” SMS Flathead
1/2” Self-Drill Pan
1/2” Self-Drill Pan Painted
3/4” Machine Flathead
7/8” Machine Pan Painted
1” SMS Pan
1” SMS Pan Painted
1” Machine Pan Painted
1-1/2” Machine Flathead
1-1/2” Machine Flathead
2” SMS Pan Painted
5/8” SMS Pan Painted
1-1/4” SMS Pan
X
VIEW
K
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
1. Lock leg of screw cover (K) into short leg of rain cap screw
track. Press on other leg to snap it into long leg of track.
Make sure screw cover snaps into screw track along the
entire length of the rain cap.
2. Repeat this process with remaining side screw covers.
K
K
X
VIEW
c
I
J
1. Look at the center hole of the rain cap. If the mounting surface can be
seen in the entire hole, proceed to step a2. If the mounting surface
cannot be seen in the entire hole, or if there is space above the rain
cap, then completely insert the 3/16” plug into the middle hole, then
proceed to step b.
2. Using the drill bit and three 1” screws, fasten the rain cap to the
mounting surface, then proceed to step c.
1. If a plug was installed in the middle hole, you will need
to install the rain cap extender (I).
2. Place the rain cap extender over the rain cap as shown,
with both ends being ush.
3. Using the drill bit and three 1” screws bag, fasten the
rain cap extender to the mounting surface.
b
X
VIEW
B
SHORT LEG
PESTAÑA CORTA
RAINURE
COURTE
I
3/16” Plug
x 1
1
2
3
12
9
4
13
14
5
6
7
8
NO 1